Three Useful Building Tips

Three Useful Building Tips

When building anything from a shed to a house, there are many issues and problems that can arise, many of which are easy fixes! Mixing Concrete The following mix creates a typical More »

 

Three Useful Building Tips

When building anything from a shed to a house, there are many issues and problems that can arise, many of which are easy fixes!

Mixing Concrete

The following mix creates a typical mortar that is useful for brickwork and paving slabs. For large amounts, mix in a wheelbarrow, using an old bucket to measure.montazh

  • Three to four parts coarse sand
  • One part cement
  • One part water (give or take)

First, thoroughly mix the dry ingredients together. This can be done by hand with a shovel, or you can use a drill attachment. Next, add the water bit by bit, mixing as you do until you reach the desired consistency. It should be wet, but capable of holding a peak. Be sure to get in the corners of the container and ensure that all the elements are well mixed throughout. If the mix is too dry, it will be prone to crumbling, so more water should be added. On the other hand, if it’s too wet, mix in more sand and cement. Bear in mind that the weather plays a part and on hotter days, a wetter mix is better.

Repairing Plaster

Prepare the damaged surface by removing any loose bits and scratching ridges onto where you’ll apply the plaster. As with cement, the mix should be wet but firm, apply the water little by little, stirring constantly. Apply with a scraper, but be quick! It’ll need at least 12 hours to dry fully before sanding down.

Decorating a room

Preparation takes the most time when painting and decorating. Remove as many objects from the room as possible, such as curtains, and be sure you’ve covered everything else in dust sheets. Use masking tape to cover light switches or any other features you don’t want to paint and repair any damaged plaster a day in advance.

  • Clean and dust the walls
  • Remove any loose or chipped paint
  • If necessary, apply a layer of primer – not necessary if you’re painting over previously painted walls.
  • Allow at least two hours between coats to allow for drying, otherwise you’ll suffer from air bubbles.

Leave a Reply

Your email address will not be published. Required fields are marked *